- Model NO.: 8800B
- Material: Silicone
- Shape: Half Face
- Trademark: YILE
- Origin: Taizhou, China
- Mask Application: Dust Mask
- Mask Type: Safe-Type
- Materail: Silicone
- Specification: SGS
- HS Code: 9020
For dust poof and poison gas prevention.
Medical silicon mask: Soft and safety, good sealing. The electric-drive fan can support enough air, comfortable and large air flow
Dust proof and poison gas prevention
Check the filter and face piece which should be intact. Make sure that the valve and device are in right position, if there is abnormal, please replace the new one.
If the cartridge is damaged, damped or users feel hard to breath or smelt the smell. Please leave the working place as soon as possible. Then replace the new cartridge for security.
Please clean the dust which covered on the cartridge. Don't us high pressure jet or water.
Cartridge installation(Before use, please choose the suitable cartridge):
Insert the cartridge as the arrows. (Cartridge selection A type cartridge is preventing the organic gas).
Dust filter 9130-1 can be installed outside of cartridge. It anti dust and can extend the cartridge life.
Push the cartridge and make sure it's lock the connector.
Battery box installation:
2A dry battery
Alkaline cell battery
(Both two kinds of batteries can be use, but can't charge the battery in battery box)
Don't mix different batches of battery
Insert the batteries according the instruction, then close the cover
Two kinds of wind speed, In the initial, the air volume is 40-100L/min, It will engender different air volume, due to battery's charge and cartridge's usage time.
Please hang the battery box on the belt to avoid falling off.
1.1 Adjust the elastic band in advance.
1.2 Posit the mask under your chin with the nose-piece up.
1.3 Mold the nose area to the shape of your nose by pushing inward while moving your fingertips down both sides of the nose-piece
1.4 Put the top trap over your head, resting it high at the top back of your head.
2. Adjust the elastic band and pull from both sides.
3. The seal of the mask on the face should fit snugly, check prior to each wearing.
4. To check fit, don't start the fan, put you hand on the air inlet until you can't breath.